Removing The Expansion Card Riser - Dell EMC PowerEdge R240 Installation And Service Manual

Removing the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Open the blue expansion card riser retention-latch located on the system.
2. Holding the blue touch points, lift the expansion card riser out of the system.
Figure 39. Removing the expansion card riser
3. If you are not replacing the expansion card riser, install a expansion card riser filler bracket by performing the following steps:
a. Align the expansion card riser filler bracket with the slot on the system.
b. Push the expansion card riser filler bracket downward until firmly seated.
c. Close the blue expansion card retention latch by pushing the latch down until the latch snaps into place.
d. Using a Phillips #2 screwdriver, tighten the screw to secure the expansion card riser filler to the chassis.
Figure 40. Installing the expansion card riser filler
Safety instructions.
Before working inside your
PowerEdge R240 installing and removing system components
system.
61