Removing Expansion Card From The Expansion Card Riser - Dell EMC PowerEdge R240 Installation And Service Manual

Figure 42. Installing the expansion card riser
Next steps
1. Install the air shroud.
2. Follow the procedure listed in the

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. If installed, remove the expansion card
5. If applicable, disconnect the cables from the expansion card.
Steps
1. Turn-over the the expansion card riser, and holding the expansion card by its edges, remove the card from the riser.
After working inside your system.
Safety instructions.
Before working inside your
riser.
PowerEdge R240 installing and removing system components
system.
63