Table of Contents
Advertisement
2
Getting Started
A. Design and Installation Considerations
The Plaza series gas appliance is designed for outdoor use
and may be installed as a stand alone unit or built against a
wall as long as it is non-combustible and comes to the edge
of the opening of the burner. Do not cover the top of burner.
Outdoor spaces - For the purpose of these instructions,
an appliance is considered to be outdoors if installed with
shelter no more inclusive than:
1. With walls on all sides, but no overhead cover
2. Within a partial enclosure which includes an overhead
cover and no more than two side walls. These side
walls may be parallel, as in a breezeway, or at right
angles to each other; or
3. Within a partial enclosure which includes an overhead
cover and three sidewalls, as long as 30% or more
of the horizontal periphery of the enclosure is perma-
nently open.
Note: Screen may be used on the open sides of the shel-
ter, 14x18 and 16x18 screen mesh is approved for use.
DO NOT use solar screen or no-see-um screen.
CAUTION
Check building codes prior to installation.
•
Installation MUST comply with local, regional,
state and national codes and regulations.
•
Consult insurance carrier, local building, fire
officials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
When planning an appliance installation, it's necessary to
determine the following information before installing:
•
Where the appliance is to be installed.
•
Gas supply piping.
•
Framing and finishing details.
Moisture Resistance
This outdoor gas appliance will shed moderate amounts of
water, but is not waterproof. Water and condensing water
vapor may enter the enclosure under certain conditions
Note: Take drainage into consideration when building
enclosure. Water MUST be able to drain away from the
enclosure.
6
Outdoor Lifestyles • ODPLAZA-L24S-B Installation Manual • 4079-311 • Rev F • 08/20
B. Inspect Appliance and Components
•
Remove the appliance and components from the
packaging and inspect for damage.
•
Report any parts damaged in shipment to your dealer.
Parts included with the starter package:
-
Pan assembly
-
(2) end caps
-
Flexible bulk head with propane orifice.
-
(18) hex head screws
-
(1) 1/2 in. NPT to 3/8 in. flare adapter
-
Burner tube
-
(3) burner tube brackets
-
Flex line
-
Valve bracket
-
Natural orifice
-
Safety pilot gas valve
-
30 inch thermopile
-
Valve knob
•
Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
WARNING! Risk of Fire or Explosion!
could impair safe operation. DO NOT install damaged, in-
complete or substitute components. Keep appliance dry.
Hearth & Home Technologies disclaims any responsibil-
ity for, and the warranty will be voided by, the following
actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Improper positioning of the media.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire or Explosion! DO NOT use this
appliance if any part has been under water. Call a qualified
service technician to inspect the appliance and to replace
any part of the gas control system which has been under
water.
Damaged parts
Advertisement
Table of Contents
