DRIVING THE MACHINE
OPERATING IN WATER OR MUD
The machine can be operated in water up to the upper
edge of the upper rollers only if worksite footing has suffi-
cient strength to prevent the machine from sinking past the
upper edge of the upper roller, and only if the water is flow-
ing slowly.
When operating in such conditions, check the machine's
560 mm
position often. Reposition the machine if necessary.
(1 ft 9 in)
M104-05-009
Avoid submerging the swing bearing, swing gears and cen-
ter joint.
If the swing bearing, swing gears and center joint are sub-
merged, remove the drain plug to drain mud and water.
Clean swing area. Install plug. Lubricate swing internal
gear and swing bearing.
Swing Internal Gear Capacity: 4.4 L (4.7 US qt)
Lubricate swing bearing. (See Maintenance Guide, 500
hours)
4-8