Troubleshooting - Primera Accent User Manual

TOC
5. The Lamination Roller can be cleaned periodically to avoid
buildup of residue or dust.
6. You may also want to use a small electronics vacuum to
remove any particles from inside the case.
7. Clean the Ribbon Deflector. This is the metal piece located
inside the top cover in front of the rubber Lamination
Roller. This can accumulate debris that can leave fine
vertical scratches in thee disc. Simply run a fingernail
across the deflector to clear it of debris, then wipe it clean
with isopropyl alcohol.
C. TROUBLESHOOTING
Problem
Will not Laminate
I do not see an option
in PrimoDVD to
laminate discs
The Overlaminate Film
is not adhering properly
to my discs; there are
patchy areas where the
film is not sticking to the
disc label.
The Overlaminate Film
appears to be wrinkling,
with scratch-like marks
appearing across the
surface of the disc
Resolution
Check Power to the Laminator
•
Make sure that the Ready LED is
•
on and steady indicating the
Laminator's Heat Roller
achieved normal operating
Temperature
In PrimoDVD, click Robotics then
•
Options. You should see a
Laminate check box.·
If you do not see this option in the
•
Robotic Options dialog box, install
the software on the install disc
provided with your Laminator
Stand. There is an updater on this
disc that will add this functional.
Increase the heat setting with the
•
Heat Slide Bar on the Laminator's
Control Panel. Slide the Heat
Setting one or two hash marks
toward the front of the Laminator
to increase the heat setting.
Decrease the heat setting with
•
the Heat Slide Bar on the
Laminator's Control
the Heat Setting one or two hash
marks toward the rear of the
Laminator to decrease the heat
setting.
Maintenance and Troubleshooting 11
INDEX
has
Panel. Slide