Laminating Discs In Stand-Alone Operation - Primera Accent User Manual

TOC
C. LAMINATING DISCS IN STAND-ALONE OPERATION
Now that you have successfully loaded the Lamination Film,
you are ready to laminate your discs.
A. Turn the Laminator Power Switch to the ON position. Press
the Laminate Button. The
from the Laminator. Press Laminate again to begin
the Thermal Roller to operating temperature. The Ready
LED should flash intermittently while the roller is heating.
The process should take about 8 minutes.
NOTE: The Laminator will automatically go into
30 minutes of inactivity.
B. Once the READY LED is on and steady, the Laminator is at
heat and ready to laminate your discs. You may need to
make adjustments to the Laminator heat settings to ensure
high quality output. Start with a test lamination to see if
any adjustment will need to be made. This is done as
follows:
a.
b. Place a disc on the Disc Tray.
c. Press the
d. The disc will be drawn into the Laminator, laminated
and the tray will be ejected.
e. Examine the disc. If the lamination looks spotty, more
heat is required. Increase the intensity. If the
lamination shows scratch-like marks, the film is getting
too hot and wrinkling. Reduce the heat setting.
Set the Lamination Heat Slide Switch to the middle.
Laminate
Wrinkle in film
caused by
excessive heat
Disc Tray will automatically eject
'cool
Button.
Uneven coverage
due to
inadequate heat
Lamination Film and Optical Media 7
INDEX
heating
down' mode after