Table of Contents
Advertisement
F. TROUBLESHOOTING
Problem
Will not Laminate
I do not see an option
in PrimoDVD to
laminate discs
The Overlaminate Film
is not adhering properly
to my discs; there are
patchy areas where the
film is not sticking to the
disc label.
The Overlaminate Film
appears to be wrinkling,
with scratch-like marks
appearing across the
surface of the disc
There is a disc jammed in
my Laminator - the tray
has stalled.
G. TECHNICAL SUPPORT
If you have difficulties in operating your Laminator, the
procedures in this manual should, in most cases, solve the
problem. If you still have difficulty, call Technical Support at
the number listed on the insert in your Laminator suppy pack.
TOC
Resolution
Check Power to the Laminator
•
Make sure that the Ready LED is
•
on and steady indicating the
Laminator's Heat Roller has
achieved normal operating
Temperature
In PrimoDVD, click Robotics then
•
Options. You should see a
Laminate check box.·
If you do not see this option in the
•
Robotic Options dialog box, install
the software on the install disc
provided with your Laminator
Stand. There is an updater on this
disc that will add this functional.
Increase the heat setting with the
•
Heat Slide Bar on the Laminator's
Control Panel. Slide the Heat
Setting one or two hash marks
toward the front of the Laminator
to increase the heat setting.
Decrease the heat setting with
•
the Heat Slide Bar on the
Laminator's Control Panel. Slide
the Heat Setting one or two hash
marks toward the rear of the
Laminator to decrease the heat
setting.
Most likely the disc is not
•
seated properly in the tray.
Clear the jam by opening
the top cover, and removing
the disc from the laminator.
If the Overlaminate film has
torn, it can be reattached to the
supply roll. Once the jam has
been cleared, close the cover
and press the Laminate button;
the job will continue.
Optical Disc Laminator Connectivity Guide 15
Advertisement
Table of Contents
