Section 3: Interpreting The Laminator's Status Leds; Power Led; Ready Led - Primera Accent User Manual

TOC
Section 3: Interpreting the
The LED Status Lights are located on the
These LEDs can tell you a lot about what is happening with
your Laminator at any given
moment. To accurately interpret
what is meant when these LEDs
are on, off or flashing please
refer to the following chart:
A.

POWER LED

Status
On Solid
Flashing Rapidly
Flashing Slowly
B.

READY LED

Status
On Solid
OFF
ON Flashing OFF
(LED is flashing with
longer intervals where
LED is on)
OFF Flashing ON
(LED is flashing with
longer intervals where
LED is off)
Laminator's Status LEDs
Interpreting the Laminator's Status LEDs 9
INDEX
Control
Power
Ready
Condition
Power is on, normal operation
Ribbon Out Error
Open the Front Cover and replace
the ribbon as described in section
2-B. If you should see this error
and the ribbon is NOT out, you
may have encountered a media
jam or internal error. Clear any
torn or damage media, then press
and hold the Laminate button
seconds to reset the Laminator.
Disc Out error, if using with a
Primera duplicator, make sure
discs are loaded, press Laminate
button to continue operation.
Condition
Laminator's Heat Roller
achieved normal operating
temperature.
Laminator's Heat Roller is not
at operating temperature.
Laminator's Heat Roller is heating
up to normal operating
temperature.
Laminator's Heat Roller is
cooling down.
Panel.
for 5
has