Laminating Discs In Stand-Alone Operation - Primera Accent II User Manual

TOC
C. LAMINATING DISCS IN STAND-ALONE OPERATION
Now that you have successfully loaded the Lamination Film,
you are ready to laminate your discs.
A. Turn the Laminator Power Switch to the ON position. Press
the Laminate Button. The
from the Laminator. Press Laminate again to begin
the Thermal Roller to operating temperature. Move the
Temperature Control Lever to the desired setting. (The
middle setting is recommended initially). The Ready LED
should flash intermittently while the roller is heating. The
process should take about 8-15 minutes.
B. Once the READY LED is on and steady, the Laminator is at
heat and ready to laminate your discs. You may need to
make adjustments to the Laminator heat settings to ensure
high quality output. Start with a test lamination to see if
any adjustment will need to be made. This is done as
follows:
a.
b. Press the
c. The disc will be drawn into the Laminator, laminated
and the tray will be ejected.
d. Examine the disc. If the lamination looks spotty, more
heat is required. Increase the intensity. If the
lamination shows scratch-like marks, the film is getting
too hot and wrinkling. Reduce the heat setting.
Place a disc on the Disc Tray.
Laminate
Wrinkle in film
caused by
excessive heat
Disc Tray will automatically eject
Button.
Uneven coverage
due to
inadequate heat
Lamination Film and Optical Media 7
INDEX
heating