Monoblock Recirculation Filter (Optional); Led Lighting - Novy Pureline Cubic 6830 User Manual

Cleaning the grease filter
The metal grease filter can be cleaned by hand or in a dish-
washer. We recommend cleaning the grease filter by hand.
Cleaning the filter by hand:
− Immerse the filter in a solution of boiling water to which
a degreasing detergent has been added.
− Use a brush for cleaning
− Then rinse the filters with warm water under a tap and
allow them to dry.
Cleaning the filter in a dishwasher:
When cleaning in a dishwasher the filter may discolour as a
result of the salt content. This does not affect its operation.
− Use a customary dishwasher detergent
− Do not put the saturated grease filters together with
crockery in the dishwasher
− Select a programme with a low temperature
− After cleaning allow the filter to drain.


When cleaning in a dishwasher the filter may
discolour as a result of the salt content. This
does not affect its operation.
Replacing the grease filters
− Before replacing the grease filter, clean the edges of the
part in the extractor hood in which the filter is placed.
− Grasp the filter with 2 hands.
− Make sure that the lock or the lip on the filter is on the
bottom side.
− Insert the back of the filter in the opening, press the filter
upwards at the front and make sure it clicks tight.

You can obtain a new grease filter from a dealer
or the Novy website. Article number grease
filter: 6830.020(2x).

3.4 Monoblock recirculation filter (optional)

When selecting recirculation, always set the recirculation
programme on the extractor hood (see paragraph 2.4)
If recirculation is chosen the appliance is connected to an
outlet box with a monobloc recirculation filter, or a monob-
loc recirculation filter is fitted in the extractor hood behind
the grease filter.
Replacement indicator monobloc recirculation filter

Indication: red indicator light stays on
After a set time a red indicator light on the appliance shows
that the monobloc filter must be replaced.
Reset the replacement indicator

After replacing the monblock filter(s), carry out
the following action. The motor of the cooker
hood must be running. Simultaneously press
and for 3 seconds until the red indicator led
3
flashes 3 times for confirmation. If the cooker
hood is not reset, it will automatically reset
after the motor of the cooker hood has been
switched on 10 times.
Installing the monoblock filter
Refer to your recirculation kit manual for removal and
installation of the monoblock filter.

You can obtain a new monobloc filter from
a dealer or the Novy website.

3.5 Led lighting

Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down sufficiently.
1. Carefully press the spotlight holder; next, remove the
spotlight holder by means of a tilting movement.
2. Removing the LED spotlight:
A. First disconnect the cable leading to the LED spotlight
to be replaced. Disconnecting is done by releasing the
lock by applying a light pressure and pulling it off at
the same time.
B. Then remove the LED spotlight to be replaced by making
a soft rotating movement counterclockwise.
C. Remove the LED spotlight to be replaced from the
bayonet ring.
– 39 –
2