Cleaning And Maintenance; General Maintenance; Removing The Bottom Panel; Grease Filter - Novy Pureline Cubic 6830 User Manual

Hide thumbs Also See for Pureline Cubic 6830:
Table of Contents

Advertisement

Available languages

Available languages

3 CLEANING AND MAINTENANCE


Follow all instructions as described in the Con-
ditions for Safety and Use section.

Follow the cleaning instructions below for a
longer working life and optimal operation of the
appliance.

The bottom panel, grease filter and recircula-
tion filter can fall out when you are handling
them. This can result in damage. Make sure you
hold the bottom panel and the filter(s) securely
at all times when handling them.

WARNING! Risk of injury! Open and close the
bottom panel slowly. Use a stable stepladder
and pay attention to stability. Do not step on the
hob or the worktop surface.

3.1 General maintenance


Allow the lighting to cool down sufficiently be-
fore you start cleaning the extractor hood.

Never use aggressive, abrasive or chlorinated
products.

Do not use a high pressure or steam cleaner.
Stainless steel
Clean with a cleansing tissue with mild cleaning agent
then dry with a soft cloth. Maintenance of the stainless
steel can be performed with the Novy cleaner (906060).
Coated parts of the extractor hood
The extractor hood can be cleaned with a damp cleansing
tissue and a mild cleaning agent.
Glass
Glass parts of the extractor hood can be cleaned with
a soft cloth and a glass cleaner.

3.2 Removing the bottom panel

If the bottom panel is to be removed from the cooker hood
for cleaning, proceed as follows:
− Grasp the bottom panel at the left and right ends.
− Slowly tilt the bottom panel downwards and continue
to hold it in place.
− As soon as the bottom panel is at a 90º angle downwards,
the bottom panel can be slid to the right to remove it
from the hinges. Here you will feel some resistance. Do
this with caution to prevent damage to the cooker hood.
Make sure you hold the bottom panel securely at all times.
− The bottom panel can then be cleaned by hand. The
bottom panel is not suitable for cleaning in the dishwasher.
− Before reinstalling the bottom panel, immediately clean
the accessible parts on the inside of the cooker hood.
− To replace the bottom panel, grasp the bottom panel at
the left and right ends and hold it in place. Make sure
you hold the bottem panel securely at all times.
− Hold the bottom panel in a 90º angle downwards and
slide the bottom panel to the left over the hinges until
you notice a click.
− The bottom panel cannot be closed if the bottom panel
is not fully positioned over the hinges.
− The bottom panel can then be closed.

3.3 Grease filter


If the following instructions are not carried out,
serious soiling can cause a fire hazard.
Indication cleaning grease filter
Indication: 4 flashing indicator lights
After 20 cooking hours 4 flashing indicator LEDs show
that the grease filter must be cleaned.
Reset the cleaning indicator
When you replace the grease filter after clean-
ing, it is sufficient to press the
seconds to again set the indicator.
If you do not do this the indicator light will continue to flash
when switching on the extractor hood.
Accessing the grease filter
Take hold of the right and left side of the bottom panel
(A) and pull down simultaneously. Remove the filter (B) by
tak ing hold of its hook and pulling down.
– 38 –
key for 5
2

Advertisement

Table of Contents
loading

Table of Contents