Table of Contents
Advertisement
User manual
P/N 3-9008-553
4
Prepare the control valve for use
4.1
Lifting conditions
WARNING
CRUSHING HAZARD
During installation or removal of a control valve, always place the unit on a stable
platform or surface that supports its assembled weight.
Failure to comply may allow the control valve to roll, resulting in death, serious injury or
equipment damage.
WARNING
LIFTING HAZARD
The lifting instructions are for installation and removal of a Daniel control valve only and
do not address lifting the control valve while it is attached or bolted to piping.
Failure to follow these instructions may result in death, serious injury or equipment
damage.
CAUTION
FORKLIFT HAZARD
Do not insert the forks of a forklift into the bore when moving the control valve.
Inserting the forks may cause the meter to become unstable, resulting in serious injury
or equipment damage.
Table 4-1: Lifting and installation conditions
Conditions
Ventilation and lightning
Work area clearances and
installation height restrictions
Surface considerations
Soil/floor loadings and
product/piping support
User manual
Prepare the control valve for use
Description
Install the control valve in a well lit and ventilated location, not
less than one meter (approximately three feet) from source of
ignition or source of heat which might damage the unit.
Refer to
Minimum clearances for installation, operation and
maintenance
for clearances.
Stable surface.
Follow local procedures that meet the standards for soil/floor
loading and product/piping support.
USER MANUAL
November 2020
29
27
www.Daniel.com
Advertisement
Table of Contents
