Prepare The Control Valve For Use; Lifting Conditions - DANIEL 762 User Manual

4

Prepare the control valve for use

Topics covered in this chapter:
•

Lifting conditions

• Lifting requirements for personnel
• Configure the control valve
4.1 Lifting conditions
WARNING!
CRUSHING HAZARD
During installation or removal of a control valve, always place the unit on a stable platform or
surface that supports its assembled weight.
Failure to comply may allow the control valve to roll, resulting in death, serious injury or
equipment damage.
WARNING!
LIFTING HAZARD
The lifting instructions are for installation and removal of a Daniel control valve only and do not
address lifting the control valve while it is attached or bolted to piping.
Failure to follow these instructions may result in death, serious injury or equipment damage.
CAUTION!
FORKLIFT HAZARD
Do not insert the forks of a forklift into the bore when moving the control valve.
Inserting the forks may cause the meter to become unstable, resulting in serious injury or
equipment damage.
Table 4-1:
Conditions
Ventilation and lightning
Surface considerations
User manual
Lifting and installation conditions
Description
Install the control valve in a well lit and ventilated location, not
less than one meter (approximately three feet) from source of ig-
nition or source of heat which might damage the unit.
Stable surface.
USER MANUAL
Prepare the control valve for use
57
www.Daniel.com
63