DANIEL 700 User Manual page 6

MODEL 700 CONTROL VALVE
Introduction
November 2020
Inform and train all personnel in the proper installation, operation, and maintenance of
this product. To ensure safe and proper performance, only informed and trained personnel
should install, operate, repair and maintain this product. For further questions about
training requirements, contact your local Daniel representative.
Operations risk assessment must be used and followed in conjunction with this document
when performing all online retrieval operations.
Ensure that all end user and installation specific safety requirements are read, understood
and adhered to.
Ensure that any operator that is conducting work on the equipment, is following end user
guidelines on the use of protective equipment including, but not limited to:
•
•
•
•
•
•
Additional PPE may be required depending on facility requirements and MSDS
requirements, if applicable. Failure to comply may result in personnel injury.
RISK TO PERSONNEL AND EQUIPMENT
Failure to follow the installation, operation or maintenance instructions for a Daniel
product could lead to serious injury or death from explosion or exposure to dangerous
substances. To reduce the risk:
•
•
•
NOTICE
Observe all precautionary signs posted on the equipment to avoid serious injury.
RISK TO PERSONNEL AND EQUIPMENT
Operation of this product on pressurized lines may potentially imply operational risk for
personnel and equipment from the potential escape of hot gas or liquid, which could
result in serious injury.
Observe all precautionary signs on the equipment.
8
6
www.Daniel.com
Safety helmet or hard hat
Steel-toed shoes
Safety glasses
Working gloves (suitable for mechanical operations)
Chemical resistant latex gloves or the equivalent
Long-sleeved, fire-retardant shirt and fire-retardant trousers or full-length fire
retardant coveralls
WARNING
Comply with all information on the product, in this manual, and in any local and
national codes that apply to this product.
Do not allow untrained personnel to work with this product.
Use Daniel parts and work procedures specified in this manual.
WARNING
User manual
P/N 3-9008-553
Daniel Series 700 Control Valve