Description - Hilti TE 60-ATC Operating Instructions Manual

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chiseling Chisel
position
adjustment

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered combihammer with pneumatic hammering mechanism. The ATC (Active
Torque Control) function of the TE 60-ATC / TE 60T‑ATC provides greater operating comfort while drilling.
The tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling.
The power tool is equipped with electronic overload protection. If the power tool is overloaded for a continuous period,
motor speed will be reduced automatically and, if necessary, the motor may be stopped completely. When the control
switch is released and then pressed again, the motor immediately regains full power. When restarting, care should
thus be taken to ensure that the power tool is held securely with both hands.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and "Operation").
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
16
Wear ear
hat protection
Drilling
without
hammering
Volts
Watts
Wear
protective
gloves
Revolutions
per minute
Lock symbol
Location of identification data on the power tool
Hammer
drilling
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Type:
Amps
Generation: 02
Serial no.:
Alternating Hertz
current
Diameter Double
insulated
Rated speed
under no
load
Equipped
with theft
protection
system