Cabling - Nortel Meridian 1 Description, Installation, And Maintenance

Page 52 of 126 Installation and configuration

Cabling

553-3001-359 Standard 1.00 October 2003
Procedure 5
Installing the MIVS card
1 Identify the IPE card slot selected for the MIVS card. Refer to Table 9,
"MIVS installation into card slots in different IPE modules," on page 50.
2 Make sure that the PCMCIA hard drive card is in the lower PCMCIA slot
on the faceplate, and that it is firmly seated.
3 Pull the top and bottom extractors away from the MIVS faceplate.
4 Insert the MIVS card into the card guides and gently push the card until
the card makes contact with the backplane connector.
5 Push the top and the bottom extractors firmly towards the faceplate to
insert the MIVS card into the faceplate connector and to lock the card
firmly in place.
6 Observe the Red LED at the top of the faceplate (the card LED). This LED
blinks three times after the self-test successfully finishes. The LED then
stays ON until you software enable the MIVS card.
You connect the MIVS card to the maintenance terminal, the BGD terminal,
and your LAN through the Ethernet adapter. Before you make these
connections, however, attach the NTBK48AA cable to the DB-9 connector of
the Ethernet adapter (see Figure 5).
Note: The TTY port labeled P1 needs to be permanently connected to an
SDI port programmed as a background terminal (BGD). The P2 port is
unused in this MIVS version.