Checking The Gas Line For Leaks; Install Appliance; Installing The Anti-Tip Bracket - Bosch HDS8645U Installation Instructions Manual

* Attached to the appliance.
WARNING
Do not attempt any adjustment of the pressure regulator,
except when converting to propane. Adjustments could
lead to leaks or cause incorrect gas pressure to the appli-
ance.
Side and back view of gas range installation
Gas Location
A Gas connection
B Electrical connection
Connect the gas supply line to the unit pressure regulator
using a 1/2" flex gas line connector between manual shut-
off valve and pressure regulator. A metal flex line or fixed
metal pipe shall be used to connect gas to the appliance.
If a metal gas line cannot be used, consult your local certi-
fied electrician or local electric codes for proper grounding.
3.5 Checking the gas line for leaks
Check supply line connections for leaks using a soap solu-
tion or non-corrosive leak detection fluid. Do not use a
flame of any sort.
WARNING
Install a gas shut off valve near the appliance. After instal-
lation, it must be easily accessible in an emergency.
Turn on gas.
1.
Apply a soap solution or non-corrosive leak detection
2.
fluid to all joints and fittings in the gas connection be-
tween the shut-off valve and the cooktop. Include gas
fittings and joints in the cooktop if connections may
have been disturbed during installation. Bubbles ap-
pearing around fittings and connections indicate a leak.
If a leak appears, turn off supply line gas shut-off valve
3.
and tighten connections.
Retest for leaks by turning on the supply line gas shutoff
4.
valve. When leak check is complete (no bubbles ap-
pear), test is complete.
Wipe off all soap solution or detection fluid residue.
5.
Important Notes for Gas Connection:
– The appliance and its individual gas shutoff valve
must be disconnected from the gas supply piping
system during any pressure testing of that system at
test pressures in excess of 1/2 psi (3.5kPa).
– The appliance must be isolated from the gas supply
piping system by closing its individual manual shut-off
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 psi (3.5kPa).
3.6 Install appliance
WARNING
TIP OVER HAZARD! A child or adult can tip the range
over and be killed.
Install the anti-tip device to the structure and/or the
▶
range.
Verify the anti-tip device has been properly installed and
▶
engaged.
Engage the range to the anti-tip device. Ensure the anti-
▶
tip device is re-engaged when the range is moved.
Re-engage the anti-tip device if the range is moved. Do
▶
not operate the range without the anti-tip device in place
and engaged.
See installation instructions for details.
▶
Failure to follow the instructions in this manual can re-
▶
sult in death or serious burns to children and adults.
Check for proper installation and use of the anti-tip
▶
bracket. Carefully tip the range forward pulling from the
back to ensure that the anti-tip bracket engages the
range leg and prevents tip-over. The range should not
move more than 1" (2.5 cm).
3.7 Installing the anti-tip bracket
Ensure that the electrical connection and the gas con-
1.
nection are in the correct position.
Installation procedure en-us
15