Fitting The Rear Vent Trim; Fitting The Adjustable Feet; Connect Gas Supply - Bosch HDS8645U Installation Instructions Manual

en-us Installation procedure
approximately 3/4" (19 mm) to unhook the hinges from
the slots. Pull the door out towards you until the hinges
are clear of the oven housing.
Place the door in a convenient and stable location for
5.
cleaning.
Refit the door in the reverse order in which it was re-
6.
moved.
3.2 Fitting the rear vent trim
The rear vent trim is nested in the styrofoam packaging.
1.
Remove the packaging and the protective film from the
rear vent trim.
Place the rear vent trim into the holes intended for this
2.
purpose using the dowel pins.
Insert and tighten the enclosed screws from below.
3.
3.3 Fitting the adjustable feet
Remove all parts that are not permanently fixed, espe-
1.
cially the pan supports and burners.
2.
CAUTION Protect the floor.
Remove the accessories from the oven.
3.
CAUTION Do not use the door handle or project-
ing control panel for carrying.
Tilt the appliance and put it to the floor on the backside.
Screw the adjustable feet into the mounting holes on
4.
the underside of the appliance.
14
If the appliance needs to be moved again, screw the ad-
justable feet in fully.
Carefully move the appliance back onto its feet.
5.
Turn the adjustable feet to align the appliance.
6.
Note: Measure the installation height of the cabinetry and
adjust appliance height accordingly prior to placing appli-
ance in cabinetry.
3.4 Connect gas supply
The appliance is shipped from the factory for use with nat-
ural gas at a pressure of 5" water column.
¡ When checking for proper operation of the regulator, the
inlet pressure must be at least 1" greater than the oper-
ating (manifold) pressure above. When used with natu-
ral gas, the pressure supplied to the regulator must be
between 6" and 10.5" water column.
¡ To convert the appliance to propane gas see "Conver-
sion to propane gas (LPG)". A qualified technician or in-
staller must do the conversion.
¡ Use a flexible gas pipe with a length of at least 5 ft (1.5
m).
¡ The gas inlet to the unit is located at the right rear of the
appliance.
¡ Install the pressure regulator (supplied with unit) to gas
inlet. Postion the gasket (supplied with unit) in between
the inlet and the regulator. Position the regulator to
have it cap D → Page 25 easily accessible. Turn the
nut on gas inlet to hand tighten plus 1/3 turn.
¡ Install the gas pipe to the regulator using Teflon tape or
pipe-joint compound (resistant to propane gas and natu-
ral gas). Turn to hand tighten plus 1/3 turn. Do not ex-
ceed 1 turn for alignment, to prevent possible damage
to the gas pressure regulator.
Check inlet fittings and regulator for leaks.