Table of Contents
Advertisement
Available languages
Available languages
English
L
•
Figure M - To replace the filters, slide the outer plastic
filter over the cloth filter.
•
Align the wings of the plastic filter with the slots in the
cloth filter and twist in a counterclockwise direction.
M
•
Place filters back into the bowl pressing firmly to ensure
a secure fit.
•
To replace dust bowl, place it back onto the handle until
it "clicks" firmly into position.
iMPORTAnT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
•
Wash the filter regularly using warm, soapy water
and ensure that they are completely dry before using
again. The cleaner the filter is, the better the product
will perform.
•
It is very important that the filter is correctly in position
before use.
Nozzle / Accessories
•
Figure N - A crevice tool is built into the nozzle and
can be extended as shown in Figure N by pulling
the extension piece until it locks into position.
8
N
•
Figure O - A brush accessory is built into the
nozzle and can be flipped upwards for use.
O
•
Figure P - The nozzle can be rotated for better
access in tight spots. To rotate the nozzle, press the
button shown in Figure P and rotate the nozzle to
the left or right until it clicks into place.
P
Replacing the Filter
The filter should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate dealers.
•
Remove the old filters as described above.
•
Fit the new filters as described above.
MAINTENANCE
Bowls and filters can be washed thoroughly; however, use
only mild soap and a damp cloth to clean the main part of
the vacuum.
iMPORTAnT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
Advertisement
Table of Contents
