Nozzle / Accessories - Black & Decker CHV1410L Instruction Manual

WARNING:
the appliance without the filter. Optimum
dust collection will only be achieved with
clean filter.
• Figure K (CHV1410L ONLY) - This
vacuum has a plastic pre-filter and an
inner cloth filter. To separate the cloth
filter from the plastic filter, twist the plastic
filter in a clockwise direction.
• Remove the inner cloth filter and shake or
lightly brush any loose dust off both filters.
K
• Figure L - The dust bowl and filter can be
washed in warm soapy water. Allow to
dry before placing back into the vac.
L
• Figure M - To replace the filters, slide the
outer plastic filter over the cloth filter.
• Align the wings of the plastic filter with
the slots in the cloth filter and twist in a
counterclockwise direction.
M
• Place filters back into the bowl pressing
Never use
firmly to ensure a secure fit.
• To replace dust bowl, place it back onto the
handle until it "clicks" firmly into position.
IMPORTANT: Maximum dust collection will
only be obtained with a clean filter and an empty
dust bowl. If dust begins to fall back out of the
product after it is switched off, this indicates that
the bowl is full and requires emptying.
• Wash the filter regularly using warm,
soapy water and ensure that they are
completely dry before using again. The
cleaner the filter is, the better the product
will perform.
• It is very important that the filter is
correctly in position before use.

Nozzle / Accessories

• Figure N - A crevice tool is built into the
nozzle and can be extended as shown
in figure N by pulling the extension piece
until it locks into position.
• Figure O - A brush accessory is built into
the nozzle and can be flipped upwards for
use.
• Figure P - The nozzle can be rotated for
better access in tight spots. To rotate the
nozzle, press the button shown in Figure
P and rotate the nozzle to the left or right
until it clicks into place.
6
N
O