Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.8
Installing the fork legs
12.9
Removing the fork protector
–
Release screws
–
Release screws
B01627-10
x
Main work
–
Position the fork legs.
Info
The compression damping is located in the left fork leg COMP (white adjust-
ing screw). The rebound damping is located in the right fork leg REB (red
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
B01628-10
Position bleeder screws
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01627-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
L00227-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs. (
. Take out the left fork leg.
4
. Take out the right fork leg.
5
toward the front.
1
.
2
.
3
M8
.
5
(
p. 71)
x
p. 81)
(
p. 71)
x
p. 42)
M8
17 Nm
(12.5 lbf ft)
M8
15 Nm
(11.1 lbf ft)
.
4
25 Nm
Loctite
(18.4 lbf ft)
p. 79)
p. 79)
p. 41)
43
®
243™
.
6
Advertisement
Table of Contents
