HUSABERG FE 250 USA 2014 Owner's Manual page 92

18 SERVICE WORK ON THE ENGINE
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
101837-10
–
Remove screws
101838-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
101839-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and place it in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
101840-10
–
Remove the oil filler plug
engine oil.
Engine oil
101841-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
with the O-ring.
2
1
. Remove the oil filter cover with the O-ring.
4
out of the oil filter housing.
5
with the O-ring from the clutch cover and fill up with
7
1.20 l (1.27 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
M20x1.5 15 Nm
(11.1 lbf ft)
with the magnet and a new seal ring.
M12x1.5 20 Nm
(14.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- (
formance
90
.
6
p. 105)
p. 105)