Installing The Fuel Tank - HUSABERG FE 250 USA 2014 Owner's Manual

Table of Contents

Advertisement

12
SERVICE WORK ON THE CHASSIS
12.33

Installing the fuel tank

Danger
Fire hazard Fuel is highly flammable.
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Remove screw
L00197-11
Pull both spoilers off of the sides of the radiator bracket and lift off the fuel tank.
L00200-10
x
Main work
Check the routing of the throttle cable. (
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
Make sure that no cables are trapped or damaged.
Mount the fuel tank breather.
Mount and tighten screw
Guideline
Remaining screws, chassis
L00197-10
Position the horn, and fit and tighten screws
Guideline
Remaining screws, chassis
L00199-11
with the rubber bushing.
4
with the rubber bushing.
1
p. 59)
M6
10 Nm (7.4 lbf ft)
with collar bushings.
2
M6
10 Nm (7.4 lbf ft)
54

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe 250 eu 2014Fe 250 aus 2014

Table of Contents