Baxi Heat 616 Installation And Service Manual page 39

Rear Flue Blanking
Plate
Horizontal
Tongue
Fig. aa
Horizontal Tongue
Securing Screws
Sealing
Caps
Slot
7726858-01 (1/19)
Rear Flue Blanking
Plate
Check Seals
Fig.37
Safety
Spring
Bracket
Latch
Screw
Fig. CC
Fig. BB
Safety Bracket
Spring Latch
Fig. 38
9. Undo the screws securing the rear flue blanking plate. Firmly
grip the central spigot and pull the plate off the boiler. Ensure
that the flue connection seals remain in place (Fig. 37).
10. Lift the boiler and locate the slots in the wall bracket over
the horizontal tongues on the wall bracket. As the boiler is
pushed back the wall plate spring latch will positively engage
over the wall mounted bracket (Figs. AA, BB & CC).
11. Locate the slots in the safety bracket over the two vertical
tongues on the wall bracket and secure with the two screws
(Fig 38). Adjust the jack screw to ensure the boiler is fully
vertical and then insert the lower securing screw.
Spigot
12. If required fit the trim supplied over the flue terminal or
'make good' with sealant or cement.
13. Ensure that the terminal is positioned with the slots to the
bottom (Fig. 31). Secure the flue to the elbow with the screws
supplied (Fig. 30).
It is essential that the flue terminal is fitted as shown to
ensure correct boiler operation and prevent water
entering the flue. There must be no part of the air duct
(white tube) visible outside the property after
installation.
14. Make good between the wall and air duct outside the
building, appropriate to the wall construction and fire rating.
15. If necessary fit a terminal guard (see Section 5.3.10).
If not already done so, make the water connections, fill
the condensate trap, connect the condensate drain and connect
the gas supply as described in Sections 5.4.3, 5.4.4, 5.4.5 &
5.4.6 respectively.
Snap off rear polystyrene and
lift using lower polystyrene (can
be discarded if space is limited)
Installation 6
600 Heat 39