Table of Contents
Advertisement
OPERATING INSTRUCTIONS
1. Fill the bath to at least 3 inches above the jets before activating the pump.
2. The pump is activated by an on/off switch. Each depression of the button switches the power either on or off.
Do not repeatedly depress the switch in rapid order if you do not see the whirlpool function right away,
as it may take a few seconds before you can see it fully operating.
3. If any factory installed fittings are removed do not operate the unit. A safety hazard may occur.
4. Do not use bubble bath when you operate the whirlpool pump.
This might cause excessive foaming.
5. Both air and whirlpool systems are plumbed in a way that water will
drain from the plumbing easily.
ON-OFF SWITCH
The whirlpool bath pump is activated by a on-off switch. Each depression of the switch
will actuate the pump. If off, one depression will turn the pump on. If on,
the next depression will turn it off.
JET OPERATION AND ADJUSTMENT
The jets can be easily adjusted by pointing the jet-nozzle in the desired direction. For units
with Hydro Jets, the strength of the waterflow and air induction can be regulated through
twisting the jet-nozzle. Twisting the nozzle clockwise will decrease the water flow and finally completely
turn off the water flow of that particular jet. If the nozzle is twisted counter- clockwise then the water
flow will increase up to its maximum flow.
ADJUSTABLE FLOW CLEAN JET
The water flow action may be adjusted from vigorous to soft by rotating the nozzle clockwise for vigorous and
counterclockwise for soft.
NOTE: You may balance the air volume control and nozzle adjustment for the most desirable condition.
Softer Massage
(counter-clockwise)
More Vigorous Massage
(clockwise)
754764-100 Rev. D
:
™
Small Jet
20
Large Jet
Softer Massage
(counter-clockwise)
More Vigorous Massage
(clockwise)
AIR SWITCH
Advertisement
Table of Contents
