Table of Contents
Advertisement
1
INSTALLATION INSTRUCTIONS:
Place the tub on a nished, level oor in the
desired location.
Using an erasable pencil or marker, trace the outline of
the base of the tub on the oor. (See Fig. 1)
2
Using the adjustable feet on the underside of the tub, ensure
that the tub is level.
Ensure that there is a gap between the tub base and the oor.
Gap shall not exceed 1/8" [3 mm]. (See Fig. 2)
3
REMOVE THE TUB
Using the traced outline for reference, con rm that the
drain/waste outlet in the oor will align with the tub drain outlet.
(Tub drain outlet will be located in the center of the traced
outline. See Fig. 3)
Note: The drain/waste outlet must be installed in
accordance with all local building codes.
All drain connections must be made using an
access created beneath the tub.
4
INSTALLING THE 1-1/2" DIAMETER TAIL PIECE ASSEMBLY INTO P-TRAP
The tail piece assembly, consisting of a anged tail piece, drain tail piece
gasket and slip-joint nut used to connect the the tub drain to the drain/waste
outlet, is included with this product.
The 1-1/2" diameter tail piece is compatible with drain provided. (See Fig. 4)
Slide the slip-joint nut over tail piece towards the anged end as shown.
Slide the P-trap slip-joint nut and seal over the tail piece as shown.
Insert the tail piece into the P-trap.
The ange of the tail piece should be approximately 5-3/4" [145 mm] or
4-7/8" [124 mm] depending on model, above the finished floor when fully
inserted into the P-trap.
The tail piece can be cut if necessary.
1/8" MAX
(3mm)
FINISHED FLOOR
DRAIN
TAIL PIECE
ASSEMBLY
(INCLUDED)
For MODEL#
D12536-004
5-3/4" [145 mm]
For MODEL#
D12536-014
4-7/8" [124 mm]
FINISHED
FLOOR
P-TRAP
SLIP-JOINT NUT
& SEAL
(PROVIDED BY
INSTALLER)
- 6 -
FIG. 1
FIG. 2
FLOOR CUTOUT
TRACED
FIG. 3
OUTLINE
THREADED PORTION
OF DRAIN BODY
DRAIN TAIL PIECE GASKET
SLIP-JOINT NUT
TAIL PIECE
(PROVIDED BY
INSTALLER)
FIG. 4
754988-100 REV. B (5/15)
P-TRAP
Advertisement
Table of Contents
