Table of Contents
Advertisement
SAVE THESE INSTRUCTIONS! OPERATING INSTRUCTIONS
1. Enter your American Standard
to at least 2 inches above the highest jet before activating the whirlpool pump (if equipped). Do not apply
excessive pressure when placing the handle in the close position. Do not put weight on the door when
entering and exiting the tub. It is recommended to leave the door in the open position when the tub
is not in use.
2. If your American Standard
or blower is operated by the push button switch labeled "Jets" or "Air". Both the number of buttons and their
assorted functions vary. Do not depress the button(s) repeatedly and/or rapidly as all function(s) are controlled
electronically. It may take a few seconds before any change becomes perceptible. Refer to massage
instructions sheet for more information on the controls.
3. If your American Standard
rate of the jets to your liking by moving the nozzle for direction and turning the outside ring or the nozzle
clockwise or counterclockwise for the flow rate. Some jets are notadjustable at the jet face, but can be
adjusted by the "Legs Only Massage" valve located near the seat. (If equipped.)
4. The Legs Only Massage (whirlpool & combo systems only) opens and closes the jets above the seat which
allows you to fill the tub half-way and operate only the lower whirlpool jets. The Legs Only Massage valve
must be closed when filling the tub half-way and operating the whirlpool. Failure to close the valve, when filling
the tub half-way will result in water shooting out of the jets above the seat when the pump is activated.
(If equipped.)
5. If your American Standard
blower by pushing the push button on the deck. Push the button to turn on / off and cycle for the
various speeds.
6. If your American Standard
automatically, but only when the whirlpool system is turned on. This heater is designed to extend the
comfortable bathing time, but does not reheat the bath water.
7. If your American Standard
system will turn on automatically when the whirlpool system is turned on.
8. If your American Standard
dedicated pump, suction and switch to activate the drain. Simply open the traditional drain system
(turn the overflow) and then press the Quick Drain
water falls below the suction guard, press the control switch to turn the drain system off.
walk-in bath, close the door, place handle in down position, and fill the bath
®
walk-in bath is equipped with Whirlpool Jets, Air Spa, or Combo system, the pump
®
walk-in bath is equipped with whirlpool jets, you can adjust the direction and flow
®
walk-in bath is equipped with an Air Spa system, you can activate the heated
®
walk-in bath is equipped with an in-line heater, the heating element will come on
®
walk-in bath is equipped with the Automatic Tub Clean System - Ozone, the
®
walk-in bath is equipped with the Quick Drain
®
on/off switch to activate the drain. When the
®
19
OWNER'S MANUAL
, this system has its own
®
754818-100 Rev. A
Advertisement
Table of Contents
