EN
12
Controlling and operating the lawnmower
MULCHING
Caution! Attach and remove the mulching plug only when the engine is turned off.
Caution! Use only original mulching accessories when mulching.
1. Remove the grass catcher and hold the plastic grass catcher cover with your hand (Fig. 9 – point 1).
2. Install the mulching plug into the discharge
chute (Fig. 9 – point 2) and make sure that the plug is seated
fi rmly.
IMPORTANT INFORMATION: Do not mulch tall
grass all at once, this will prevent overloading the
lawnmower mechanism and the engine.
SETTING THE MOWING HEIGHT
The mowing height is set centrally using the central mowing
height adjustment lever (Fig. 1 – point 11)
You can select from 5 positions in the range of 25 to 75 mm.
The middle mowing height is the most suitable for the majority of lawns.
Lawn damage may result when the lowest height is set.
Caution! For maximum effectiveness, please always trim the grass by 1/3 of its length only.
Mow the overgrown grass gradually and after each mowing, lower the height by one step.
To keep quality lawn, do not use the lowest mowing height setting.
REPLACING THE MOWING BLADES
Caution! Contact an authorised service centre
Caution! Prior to removing the blade, drain the oil from the oil tank.
If you wish to replace the mowing blade, remove the bolt (Fig. 10). Perform the installation according to the
provided picture.
Tighten the screw. The tightening torque is 40 Nm. When replacing the blade, replace the fastening bolt as well.
Fig. 9
Fig. 10
FZR 4615 LiBES