Table of Contents
Advertisement
Installer Manual 255-LOGIX 740-760 - Programming
6.3.9. Estimated capacity
Note
The system capacity is displayed in kilograms equivalent CaCO
before a regeneration is necessary.
Note
Value is derived from the system's resin volume input and salt amount input.
Note
The capacity is displayed for information purposes on the 740 controller. It cannot be
changed.
Set the estimated capacity on the 760 controller.
A
Press
.
→ The amount number flashes.
B
Adjust displayed capacity with
C
Press
to validate the selection and advance to the next
parameter using
Note
If using the 740 controller, programming is complete. The controller will return you to the
normal operation mode.
6.3.10. Hardness (760 on-demand controller only)
Set inlet water hardness at installation site.
A
Press
.
→ The hardness number flashes.
B
Adjust displayed hardness number with
→ Default hardness setting is 10 mg/L equivalent CACO
C
Press
to validate the selection. Initial programming is now
complete. The controller will return you to the normal
operation mode.
40 / 76
and
.
or
.
and
.
.
3
Ref. MKT-IM-001 / C - 08.10.2019
of hardness removed
3
Advertisement
Table of Contents
