Table of Contents
Advertisement
5.3.
Integration constraints
Location of a water treatment system is important. The following conditions are required:
•
level platform or floor;
•
room to access equipment for maintenance and adding brine (salt) to tank;
•
constant electrical supply to operate the controller;
•
total minimum pipe run to water heater of 3 m to prevent backup of hot water into system;
•
always install check valve to protect the softener from hot water return;
•
local drain for discharge as close as possible;
•
water line connections with shut off or bypass valves;
•
must meet any local and state codes for site of installation;
•
valve is designed for minor plumbing misalignments. Do not support weight of system on the
plumbing;
•
be sure all soldered pipes are fully cooled before attaching plastic valve to the plumbing.
Ref. MKT-IM-001 / C - 08.10.2019
Installer Manual 255-LOGIX 740-760 - Installation
25 / 76
Advertisement
Table of Contents
