Px-63Cs Internal Drive - Plextor PX-63CS Operation Manual

CHAPTER 6 ---- Drive Switch/Jumper/Dial Settings

PX-63CS Internal Drive

Factory Setting of Jumper Block
The functions shown are ON if the jumpers are installed and OFF if jumpers are
removed. The jumpers are set by the factory as follows:
Pin 3
Pin 2
Pin 1
SCSI-ID
PRTY
TERM
Installing and Removing Jumpers
Ensure power to the drive is OFF before installing or removing jumpers.
To remove a jumper, pull it off with your fingers or a pair of needle-nose pliers.
To add a jumper, push it onto the jumper pins. Three extra jumpers are supplied with the
PX-63CS in addition to the three jumpers already installed at the factory.
Caution: across each pin as shown. Do not connect one pin switch
Install jumpers
to another by installing the jumpers lengthwise. Doing so could result in
damage to the drive.
Install Jumpers This Way
14
PX-63CS/PX-65CS OPERATION MANUAL
ON (Jumper installed)
OFF (Jumper removed)
EJECT
BLOCK
TEST
Jumper
NOT Install Jumpers This Way
Do