Ultraplex Wide External Drive-Rear Panel - Plextor PX-40TSe Operation Manual

CHAPTER 5 — Drive Features
UltraPleX Wide External Drive—REAR PANEL
SCSI Interface Connector
DIP Switches: Use to select parity, term, test, block size, and eject lock options.
Leave these switches at their factory settings unless one or more of the following per-
tain to you:
Termination: Review Chapter 7 to determine if you need to turn your terminator
switch off.
Block Size: If you are working in a UNIX environment and want to boot from
your CD-ROM drive, page 20.
Eject Lock: If you work in an environment where you need to prevent others from
removing a CD-ROM disc from your drive, page 20.
SCSI ID: Use this dial to designate SCSI ID number. Rotate the dial to change the
number. If you are using more than one SCSI peripheral, you may need to change
your SCSI ID number, page 19.
Power Switch: To turn power ON/OFF.
AC Power Input: Use the power cord supplied with your drive.
Audio Output: Outputs stereo analog signal via RCA jacks. Use to connect to audio
amplifier other audio equipment.
SCSI Interface Connector In and Out: One connector should be used to link your
CD-ROM drive to your SCSI host adapter; the other to link your CD-ROM drive to
another SCSI peripheral with a daisy chain cable, page 35. You may use either con-
nector for either purpose.
14
ULTRAPLEX 40X OPERATION MANUAL
DIP Switches
In and Out
SCSI ID
Audio Output
(RCA jacks)
Power Switch
AC Power Input