Install The Plexcombo Drive; Record The Serial Number; Mount The Plexcombo Drive In The Computer - Plextor PX-320A User Manual

Install the PlexCombo Drive

Before proceeding to install the PlexCombo drive in your personal computer,
double-check your jumper setting.

Record the Serial Number

Record the serial number and TLA code of your drive on the inside front cover of
this manual.

Mount the PlexCombo Drive in the Computer

You can mount your internal PlexCombo drive in any available bay. You must
remove the small panel that covers the bay that you want to use.
CAUTION: You can install your PlexCombo horizontally or vertically. If you install it
vertically, the vertical orientation must be with the drive's right side up (as viewed
from the front).
Figure 12. For a Vertical PlexCombo Installation, Ensure the Right Side Is Up
If you don't have an empty bay, remove the existing IDE CD-ROM drive and install
the PlexCombo.
You must make a minimum of two cable connections to your PlexCombo. The two
cable connections that you must make are:
• IDE cable
• Power cable
There are also two optional cable connections:
• An analog audio cable connection if you are using a sound board in your
computer and plan to connect the PlexCombo's audio output to the audio
connector on the sound board.
• A digital audio cable connection if the sound board is equipped with SPDIF or
Digital-In and you wish to use the digital audio output from your PlexCombo.
Section 2. Installing Your PlexCombo
PlexCombo 20/10/40-12A Installation and Users Manual
17