Plextor PX-320A User Manual page 53

Troubleshooting: Writing CD-R and CD-RW Discs
Symptom Possible Causes
PlexCombo and other
IDE CD-ROM drive are
connected on the same
cable.
PlexCombo and hard
disk are connected on
the same cable.
CD-ROM drive used as
a source cannot read
data fast enough to
record at higher
speeds, such as 20X
and 16X.
Cannot write at CD-RW media is not
10X (CD-RW). high speed CD-RW.
Section 5. Maintenance and Troubleshooting
Solutions
If necessary, enable BURN-Proof
in the recording software.
Use the image writing method
(safe mode) or record at a lower
speed.
Put the IDE CD-ROM drive on the
primary bus and PlexCombo as
the Master (and the only device)
on the secondary bus.
If necessary, enable BURN-Proof
in the recording software.
Remove the PlexCombo from the
cable, set its jumper to Master,
and re-connect it to the secondary
IDE port. (Leave the hard disk
connected to the primary IDE
port.)
If necessary, enable BURN-Proof
in the recording software.
If your software does not support
BURN-Proof, copy the data to the
computer's hard disk, then record
from the hard disk to the
PlexCombo.
Use high-speed CD-RW media.
These discs are stamped with a
"High Speed CD-RW" logo.
PlexCombo 20/10/40-12A Installation and Users Manual
47