Plextor PX-504A Installation And User Manual page 3

FCC NOTICE
This equipment has been tested and found to comply with the limits for a Subpart B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee interference will not occur in a
particular installation. If this equipment causes harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications should be approved by the party responsible for compliance of FCC Rules;
otherwise, the user loses authority to operate the equipment.
LASER INFORMATION
These products have been designed and manufactured according to IEC 60825-1 on the Safety of Laser
products. This product comes under "Class 1 Laser Products."
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
A Laser Caution Label is attached on the top of the internal drive model. The label reads:
"CAUTION – CLASS 3B RADIATION WHEN OPEN. AVOID EXPOSURE TO THE BEAM."
Detail of Laser Caution Labels
The laser beam emitted from the optical pickup is invisible. Accordingly:
•
Do not open the optical pickup housing.
•
Obtain service only from Plextor-authorized personnel.
CAUTION: To disconnect the drive from an electrical current, pull out the power plug.
Top View of Drive Showing Location of Laser
Caution Labels