Rear Panel - Plextor PX-504A Installation And User Manual

Section 1. Getting Started

Rear Panel

Figure 2: Rear Panel of the Internal Drive
• Digital audio output connector: Outputs digital stereo signal. For connecting to
a sound board that supports Sony/Philips Digital Interface (SPDIF) or Digital-In.
• Analog audio output connector: Outputs analog stereo signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
• Mode jumper: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
• IDE cable connector: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
• Power connector: Connects to your computer's power supply to provide
DC +5 volts and +12 volts to the PX-504A.
6
PX-504A Installation and Users Manual