Finish Up Your Work / Clean Appliance; Troubleshooting - Kärcher WV 2 Premium Original Instructions Manual

Finish up your work / clean
appliance
Turn off the appliance.

Illustration
Unlock the suction nozzle first and

remove it from the separator, then
unlock the separator and remove it,
too.
Clean the separator and the suction

nozzle under running water (not
dishwasher safe).
Illustration
Caution: The basic appliance
contains electrical components.
Do not clean this under running
water!
Remove the wastewater tank and

pull out the closure.
Empty the wastewater tank and

rinse it with water. Close the tank
again.
Remove the wiping cover from the

spray bottle and rinse it under run-
ning water. The wiping cover can
also be washed in the washing ma-
chine at a temperature of up to
60°C (without the use of fabric sof-
teners).
Let the cleaned appliance dry prior

to assembly.
Charge the battery.

Storing the Appliance
Store the appliance upright in a dry

room.

Troubleshooting

Spray bottle does not spray
Refill detergent.

Pump mechanism in spray botte

defective, contact dealer.
Machine does not start
Check the charge/operations display:
No signal or slowly blinking signal:

Charge the battery.
With a rapidly blinking signal: In-

form your dealer.
Streaks while cleaning
Clean the pull-off lip.

Reverse the used pull-off lip:

Pull the silicone squeegee to the
side. Wet the squeegee in the area
of the curve with water or detergent.
Slide the silicone squeegee back in
the holder in reverse order.
Replace the pull-off lip if neces-

sary:
If both edges are worn after turning
the silicone squeegee around, a
new silicone squeegee is required.
Replace silicone squeegee as de-
scribed above.
Adjust the dosing of cleaning solu-

tion.
Water is leaking from the side
Empty the dirt water reservoir (max.

100 ml content).
– 7
EN
of the tank
13