Table of Contents
Advertisement
Installation
Make the electrical connections
General precautions
Electrical Hazard:
• A certified electrician must supervise all electrical work. Comply with all local codes
• Before starting work on the unit, make sure that the unit and the control panel are
• Leakage into the electrical parts can cause damaged equipment or a blown fuse.
• Make sure that all unused conductors are insulated.
• There is a risk of electrical shock or explosion if the electrical connections are not
WARNING:
Do not install the starter equipment in an explosive zone unless it is explosion-proof rated.
CAUTION:
If the pump is equipped with automatic level control and/or internal contactor, there is a
risk of sudden restart.
Requirements
These general requirements apply for electrical installation:
• The supply authority must be notified before installing the pump if it will be
• The mains voltage and frequency must agree with the specifications on the data plate.
• The fuses and circuit breakers must have the proper rating, and the pump overload
• The fuse rating and the cables must be in accordance with the local rules and
• If intermittent operation is prescribed, then the pump must be provided with
• The thermal contacts/thermistors must be in use.
Cables
These are the requirements to follow when you install cables:
14
Make sure that the impeller rotation is correct. For more information, see
impeller rotation
(page 18).
and regulations.
isolated from the power supply and cannot be energized. This applies to the control
circuit as well.
Keep the end of the motor cable above the liquid level.
correctly carried out or if there is fault or damage on the product.
connected to the public mains. When the pump is connected to the public power
supply, it may cause flickering of incandescent lamps when started.
If the pump can be connected to different voltages, then the connected voltage is
specified by a yellow sticker close to the cable entry.
protection (motor protection breaker) must be connected and set to the rated current
according to the data plate and if applicable the cable chart. The starting current in
direct-on-line start can be up to six times higher than the rated current.
regulations.
monitoring equipment supporting such operation.
Flygt 2840.180 Installation, Operation, and Maintenance Manual
Check the
Advertisement
Table of Contents
