Position Your Ap Device - TP-Link AP300 User Manual

Chapter 1
Item
Ethernet
Reset
WPS
LED
On/Off
Power
Antennas
1. 4.

Position Your AP Device

• Place your AP device in a well-ventilated place far from any heater or heating vent
• Avoid direct irradiation of any strong light (such as sunlight)
• Keep at least 2 inches (5 cm) of clear space around your AP device
• Operating Temperature: 0℃~40℃ (32℉~104℉)
• Operating Humidity: 10%~90%RH, Non-condensing
Generally, your AP device is placed on a horizontal surface. It also can be mounted on
the wall as shown below.
Note:
The diameter of the screw, 4mm<D<7mm, and the distance of two screws is 55.43mm. The screw that projects from
the wall needs around 3.5mm based, and the length of the screw need to be at least 20mm to withstand the weight
of the product.
One LAN 10/100/1000Mbps Auto-Negotiation RJ45 Port connects to a network device.
The switch for the reset function. With the device powered on, use a pin to press and
hold the Reset button for five seconds until the Power LED starts blinking, then release
the button.
Press and hold this button for two seconds to enable the WPS function. When the WPS
LED blinks slowly, the device is trying to connect or to be connected.
Press this button to turn on or turn off the LEDs.
The switch for the power. Press it to power on or off the AP device.
The power port connects to the provided power adapter.
Used for wireless operation and data transmit. Upright them for the best Wi-Fi
performance.
Description
6