Installing The Power-Adapter Port - Dell P114F Service Manual

Installing the power-adapter port

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
Steps
1. Connect the power-adapter cable to the connector on the system board.
2. Place the power-adapter port bracket on the power-adapter port.
3. Replace the (M2x2.5) screw to secure the power-adapter port bracket to the computer.
4. Adhere and route the power-adapter cable using the routing guides on the computer chassis.
Next steps
1. Install the system board.
2. Install the inner frame.
3. Install the heat-sink for integrated graphics
4. Install the secondary solid-state
5. Install the solid-state
6. Install the interposer board
7. Install the CAMM module
8. Install the battery.
9. Install the SIM card.
10. Install the base cover.
11. Follow the procedure in
80 Removing and installing components
or
drive.
drive.
module.
or long CAMM module
after working inside your
heat-sink for discrete graphics.
or memory module.
computer.