Dell P114F Service Manual page 78

Steps
1.
NOTE: Before installing the display assembly, ensure that the display hinges are opened to a 90-degree angle against
the display assembly, to fit the display assembly to the palmrest.
Align the screw holes on the hinges on the display assembly to the screw holes on the palmrest.
2. Replace the six (M2.5x3) screws to secure the hinges to the palmrest.
Next steps
1. Install the inner frame.
2. Install the heat-sink for integrated graphics
3. Install the secondary solid-state
4. Install the primary solid-state
5. Install the interposer board
6. Install the CAMM module
7. Install the battery.
8. Install the SIM card.
9. Install the base cover.
10. Follow the procedure in
78 Removing and installing components
or heat-sink for discrete
drive.
drive.
module.
or long CAMM module or
after working inside your
graphics.
memory module.
computer.