Memory Modules; Removing The Memory Module - Dell P114F Service Manual
Hide thumbs
Also See for P114F:
- Setup and specifications (32 pages) ,
- Quick start manual (18 pages) ,
- Connection manual (11 pages)
Table of Contents
Advertisement
Steps
1. Place the CAMM module into its slot on the system board.
CAUTION:
When handling the memory connector DO NOT touch the pins on the connector module, the pins
are fragile and any direct contact with the pins may damage them. Only hold the connector from the sides to
avoid contact with the pins.
2. Replace the four (M2x3.5) screws to secure the CAMM module to the system board.
3. Place the memory bracket and replace the two (M2x6) screws to secure it to the CAMM module.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Memory modules
Removing the memory module
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
NOTE:
For models shipped with a SODIMM configuration.
The figure indicates the location of the memory module and provides a visual representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
33
Advertisement
Table of Contents
