Dell P114F Service Manual page 69

Steps
1. Adhere the coin-cell battery to the palmrest and then place the system board on its slot on the computer.
2. Replace the four stand-off nuts (M2x3.5) to secure the CAMM memory.
NOTE: This step is only applicable for configurations with CAMM memory.
NOTE: In case of system board replacement, these four stand-off nuts need to be transferred from the old system
board to the new system board.
3. Replace the seven (M2x5) screws to secure the system board to the computer chassis.
4. Replace the display cable bracket on the display cable.
5. Replace the (M2x5) screw to secure the display cable bracket to the system board.
6. Connect the power button board FFC from the system board, touchpad FFC, USH daughter board FFC (for models shipped
with a USH daughter board), and SD card reader FPC cables.
7. Connect the display cable to its connector on the system board.
8. Replace the (M2x5) screw to secure the display cable bracket in place.
9. Align the screw holes, and replace the four (M2x6) screws to secure the two PCB beam connectors to the system board
and the GPU card.
Removing and installing components 69