Table of Contents
Advertisement
TRANSPORTING THE MACHINE
Transport Height
There is no fixed dimension for the transport
height as this will vary for differing applications
i.e. tractor size, carrying height, and degree of
arm fold the particular tractor cab will permit.
For the majority of installations the transport
height will be in the region of approximately 11
to 12 feet.
It is advisable that once your machine has been
installed on the tractor that it is folded into the
transport position and your own measurement
taken to ensure you have an accurate figure for
the transport height.
CAUTION: Always be aware of the transport height of
your
machine
and
manoeuvring near building, bridges and all other
overhead obstructions.
Transport Speed
The acceptable speed of transport will vary greatly depending upon the ground conditions.
In any conditions avoid driving at a speed which causes exaggerated bouncing as this will
put unnecessary strain on the tractors top hitch position and increase the likelihood of the
tension link coming into contact with the cab rear cross member.
WARNING: During transportation of the machine the PTO must be disengaged and power to
the controls switched off.
MOVING FROM TRANSPORT TO WORK
Reverting to the work position is basically a reversal of the previous work to transport
procedure.
NOTE: Always remember to release the slew ram and lift ram locks before attempting to
move the machine from the transport position.
Engaging Drive
Ensure that the rotor control lever is in the 'Stop' position before engaging the PTO shaft.
Allow the oil to circulate for a minute or so before operating the armhead levers. Position
the flail head in a safe position, increase the engine speed to a high idle and move rotor
control lever to 'Start'. After initial surging the rotor will run at an even speed.
proceed
with
care
when
Approximate transport height
32
11'
to
12'
Advertisement
Table of Contents
