Running Up Procedure; Emergency Stopping - Tiger RBM16 Operator's Manual

RUNNING UP PROCEDURE

CAUTION! Before initial use of a new machine, all lubrication points must be
greased and the gearbox and oil tank levels checked and where required topped
up before attempting to use the machine. See maintenance section for details.
'Running Up' the Machine
Ensure that the rotor control valve is in "STOP" position.
Start tractor, engage PTO and allow the oil to circulate through the return line filter for
about 5 minutes without operation of the armhead control lever.
Operate the armhead levers through their complete range ensuring that all movements are
functioning correctly.
Place the flail head at a safe attitude and move the rotor control to "START" position; after
initial fluctuation the rotor should settle to a steady speed.
Increase PTO speed to approximately 360RPM and run for a further five minutes before
disengaging and stopping tractor.
Check the hose runs and observe that they are free from any pinching, chaffing, straining
or kinks.
Re-check the oil level in the tank-and top up as necessary.

EMERGENCY STOPPING

In all emergency situations machine operation and functions must be stopped immediately;
Stop PTO operation using the tractor controls then immediately kill electrical power to the
machine using the Off (Emergency Stop) switch on the machine's control unit.
WARNING: Auto-Reset Machines
When the Auto-Reset feature is active the machines arm set is capable of
unintentional movement even when the PTO is switched off and stationary.
Always ensure that electrical power to the machine is switched off using the
Off (Emergency Stop) switch on the machine's control unit in emergency
situations and/or when the machine is not being operated.
WARNING: Cable Operated Machines
In certain conditions, and/or if the Auto-Reset feature is active, the arm sets
on cable operated machines possess the potential to move unintentionally,
even when the PTO is switched off and stationary, if the levers were to be
accidentally operated. Care must be adopted to avoid any movement of the
levers when the machine is not being operated. Ensure arm sets are lowered
fully to the ground when the machine is parked up or not in use.
19