Fitting Operator Controls - Tiger RBM16 Operator's Manual

FITTING OPERATOR CONTROL UNIT
Cable Controls
Cable control units are provided with, and attached to, a mounting bracket – the bracket
should be securely fixed to the internal mud wing or cab cladding in a suitable convenient
location that offers ease of use without interfering with normal tractor operation.
In deciding the final position of the control unit bear in mind the location of the cable run –
make sure the minimum acceptable cable bend radii of 8" (200mm) is not exceeded.
Ensure during fitting that no structural member of the tractor cab or roll bar is drilled or
damaged.
The cable rotor control valve lever on cable controlled machines will be assembled as a
component part of the main bank of controls and therefore shares the same mounting
bracket.
17