Table of Contents
Advertisement
13
INSTALLATION PROCEDURE
Do not allow people to walk under or
around the door during the installation
process as serious injury can occur.
NOTE: The opener can be installed on either side
of the door. The following instructions are for
RIGHT HAND INSTALLATIONS (as illustrated i.e.
inside the garage looking out). For left hand
installations, reverse the instruction terminology
(eg LEFT for RIGHT etc).
Preparation:
• Place the opener in manual release mode (refer to
section 10)
• Completely open the roller door. For safety, tie a rope
around the door
• Ensure the door axle U-BOLT and door mounting
bracket on the left hand side (non opener side) are
securely fastened
• Support the door with a door stand, ladder or similar
device to safely support the door
• Mark the position of the door shaft on the right hand
door bracket (for reassembly purposes)
• While the door is supported, remove the right hand
axle U-Bolt and door mounting bracket from the wall
Install the opener:
• Slide the opener over the door axle and engage the
drive legs into the door drum wheel, either side of a
spoke
• Refit the door mounting bracket to the wall
• Clamp the opener on the door axle and door bracket
in the marked position using the clamp assembly
supplied (tighten to 25 – 28 Nm)
• Remove all ropes and the support stand
• Check the operation of the door in manual mode by
raising and lowering by hand. It should operate
smoothly without sticking or binding. The disengage
handle should already be attached less than 1.8m
above the floor
Connect the power:
• Position the power cable away from the door curtain
and any moving parts
• Plug the opener into a nearby power point and turn
ON
• The opener light will turn ON and remain ON for 3
minutes
Rope
Ladder
Rope
Ladder
7
Tighten to
25-28 Nm
Advertisement
Table of Contents
