Philips LC7.2HU Service Manual page 69

8.4 Setting the Correct iTV Mode
If the i-Board is directly replaced by a new off-the-shelf module
(already programmed with platform software), the correct iTV
model still must be programmed via below sequences to get to
the correct model type with its I/O configurations.
1. Put the iTV remote control (e.g. RC2573/10) in "setup"
mode (be sure that the TV is in "iTV-mode" - see
chapter 5).
2. Push a number on the remote control to switch "On" the TV.
3. Push the "Recall" button.
4. Check the model number, listed in line 05.
If it is correct (acc. to table below), the setting is done.If the
number is incorrect, continue with the next point.
5. Enter "042420", immediately followed by "M" (Menu) key.
You now enter SDM.
6. Select and activate NVM EDIT mode.
7. Enter address "0022" (hex).
8. Push the "Arrow Down" button to activate the VAL (Value)
line.
9. Read the diversity code from the Diversity table below that
matches the TV set type you are adjusting. Enter this (hex)
number on the VAL (Value) line.
10. Select STORE to put the new value in the NVM.
11. Push the POWER button to switch "Off" the TV set.
12. Pull the mains plug.
13. Reconnect the mains plug after a few seconds.
14. The new setting is now active.
Table 8-3 Diversity table
Diversity Storage Byte
Model
32HF7965D/27
8.4.1 Required Software Versions
Be aware that the software used in these iTV sets is NOT
similar to the software in Mainstream LCD-TVs.
Ensure that the latest iTV software is used in these sets
(available on the Philips Service web site).
Address (hex) Diversity code (hex)
0x35 35
Alignments LC7.2HU LB 8. EN 69