All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by BB 0568 TV Service...
EN 2 LC4.9E AB Technical Specifications, Connections, and Chassis Overview 1. Technical Specifications, Connections, and Chassis Overview Index of this chapter: Power consumption : ≈ 450 1.1 Technical Specifications - Normal operation (W) 1.2 Connection Overview - Stand-by (W) : < 2 1.3 Chassis Overview...
Page 3
Technical Specifications, Connections, and Chassis Overview LC4.9E AB EN 3 - SCL-S C Clock (0 - 5 V) 15 - Video Red 0.7 V / 75 ohm - Ground 16 - Status/FBL 0 - 0.4 V: INT 1 - 3 V: EXT / 75 ohm...
Page 4
EN 4 LC4.9E AB Technical Specifications, Connections, and Chassis Overview Chassis Overview PLASMA DISPLAY PANEL PDP AUDIO LOUDSPEAKER AMPLIFIER PANEL COMPARTMENT POWER SUPPLY SMALL SIGNAL PANEL BOARD IBO ZAPPER LOUDSPEAKER COMPARTMENT KEYBOARD CONTROL PANEL IR & LED PANEL SIDE I/O PANEL F_15670_001.eps...
Safety Instructions, Warnings, and Notes LC4.9E AB EN 5 2. Safety Instructions, Warnings, and Notes Index of this chapter: Notes 2.1 Safety Instructions 2.2 Warnings 2.3.1 General 2.3 Notes • Measure the voltages and waveforms with regard to the Safety Instructions chassis (= tuner) ground (H), or hot ground (I), depending on the tested area of circuitry.
Page 6
For the repair of such sets nothing changes. Philips CE is producing lead-free sets (PBF) from 1.1.2005 onwards. In case of doubt whether the board is lead-free or not (or with...
Directions for Use LC4.9E AB EN 7 3. Directions for Use You can download this information from the following websites: http://www.philips.com/support http://www.p4c.philips.com...
EN 8 LC4.9E AB Mechanical Instructions 4. Mechanical Instructions Index of this chapter: Notes: 4.1 Cable Dressing • Figures below can deviate slightly from the actual situation, 4.2 Service Positions due to the different set executions. 4.3 Assy/Panel Removal •...
Page 9
Mechanical Instructions LC4.9E AB EN 9 The aluminium stands (order code 3122 785 90480) can be mounted with the back cover removed or still left on. So, the stand can be used to store products or to do measurements. It...
Page 10
EN 10 LC4.9E AB Mechanical Instructions Set Re-assembly To re-assemble the whole set, execute all processes in reverse order. Notes: • While re-assembling, make sure that all cables are placed and connected in their original positions. See Figure "Cable dressing". Be careful with the fragile LVDS cable.
Service Modes, Error Codes, and Fault Finding LC4.9E AB EN 11 5. Service Modes, Error Codes, and Fault Finding Index of this chapter: How to Enter 5.1 Test Points To enter SDM, use one of the following methods: 5.2 Service Modes •...
Page 12
EN 12 LC4.9E AB Service Modes, Error Codes, and Fault Finding How to Navigate Menu Explanation Use one of the following methods: 1. LLLLL. This represents the run timer. The run timer counts • When you press the MENU button on the remote control, normal operation hours, but does not count standby hours.
Page 13
Service Modes, Error Codes, and Fault Finding LC4.9E AB EN 13 How to Store SAM Settings 8. Displays the detected Audio (e.g. stereo/mono). To store the settings changed in SAM mode, leave the top level 9. Displays the picture setting information.
Page 14
EN 14 LC4.9E AB Service Modes, Error Codes, and Fault Finding Problems and Solving Tips Related to CSM 5.3.1 Picture Problems Note: The problems described below are all related to the TV settings. The procedures used to change the value (or status) of the different settings are described.
Page 15
UART SERVICE CONNECTOR CONNECTOR Service Tools 5.4.1 ComPair Introduction ComPair (Computer Aided Repair) is a service tool for Philips I 2 C Power Consumer Electronics products. ComPair is a further 9V DC development on the European DST (service remote control), E_06532_021.eps 180804 which allows faster and more accurate diagnostics.
EN 16 LC4.9E AB Service Modes, Error Codes, and Fault Finding • Transformer (non-UK): 4822 727 21632. • Via the blinking LED procedure (when you have no • Transformer (UK): 4822 727 21633. picture). See “The Blinking LED Procedure”. •...
Page 17
Service Modes, Error Codes, and Fault Finding LC4.9E AB EN 17 The Blinking LED Procedure Error Device Error Description Check Item Diagram HDMI Panellink C error while 7D03 Receiver/ communicating with (only in Using this procedure, you can make the contents of the error...
Page 18
EN 18 LC4.9E AB Service Modes, Error Codes, and Fault Finding Table 5-3 NVM Default values (option bit settings through NVM Editor in SAM Mode) Byte Nr. Bit Feature/Mode Description Byte 0 0 QSS (LSB) Mode of quasi split sound amplifier...
Page 19
Service Modes, Error Codes, and Fault Finding LC4.9E AB EN 19 Byte Nr. Bit Feature/Mode Description Byte 5 0 FFI Fast Filter 179(dec) 1 NNR No red reduction during blue stretch 2 MUS NTSC matrix 3 GAM Gamma control 4 CBS...
Page 20
EN 20 LC4.9E AB Service Modes, Error Codes, and Fault Finding 5.7.4 Video Processing No Power 1. Check +12 V and 3V3 at position 1J02. 2. If no supply, check the connector 1J02. 3. If it is correct, check the power supply board.
Block Diagrams, Testpoint Overviews, and Waveforms LC4.9E AB Block Diagram IBO Zapper IBO - ZAPPER PANEL FRONT END COMMON INTERFACE MOJO ANALOG BACK END 7600 7502 7500 +5VClean TDA10046HT 7700 7100 UDA1334ATS 7501 STV0700 PNX8316HS 1500 RESET_FE-N 3135 MOJO_I2S_OUT_SD 1600...
Block Diagrams, Testpoint Overviews, and Waveforms LC4.9E AB Supply Voltage Overview SUPPLY LINE OVERVIEW TOP CONNECTORS TUNER & IF SCALER SIDE CONNECTORS LED PANEL 0345 1K00 5102 5K00 0345 SUPPLY 5103 PANEL (PSU) MOJO 1M16 5K01 HERCULES 5J03 1540 SCALER...
Circuit Diagrams and PWB Layouts LC4.9E AB SSB: EPLD 1P01 E 1P02 E EPLD 1P03 F 1P04 F 1P05 G 1P06 A EAGLE INTERFACE 7N02-6 1P07 D EP1C12F256C8 7N02-3 FOR MFD ONLY 2P01 B Φ 1P06 EP1C12F256C8 Φ 2P02 B...
Circuit Diagrams and PWB Layouts LC4.9E AB IBO Zapper: Analog Back End 1500 C13 5512 G3 2500 A7 5513 H3 2501 A6 5514 I3 ANALOG BACK END 2502 B3 5528 A5 2503 C7 6503 E5 3528 2504 B3 6504 G8...
Alignments LC4.9E AB EN 81 8. Alignments Index of this chapter: 8.1 General Alignment Conditions 8.2 Hardware Alignments 8.3 Software Alignments Note: Figures below can deviate slightly from the actual situation, due to the different set executions. General: The Service Default Mode (SDM) and Service Alignment Mode (SAM) are described in chapter 5.
Page 82
EN 82 LC4.9E AB Alignments 8.3.1 SAM Menu 00035 LC4XEP1 1.14/S4XGNV 1.17 ERR 0 0 0 0 0 OP 000 057 140 032 120 128 000 . OP1 . Delta Cool Red . OP2 . Delta Cool Green -1 . OP3 .
Page 83
Alignments LC4.9E AB EN 83 8.3.4 ADC Gain and Grey Scale Alignment 8.3.5 Sound The table below shows a number of NVM settings used for • For NICAM sets: see paragraph 8.3.3. each model of TV set. Be sure to use the correct editor in the •...
Page 84
EN 84 LC4.9E AB Alignments Table 8-3 Option codes in detail, at bit level Option byte & bit table for restoring the TV set to its original Factory Default settings via the NVM Editor in the SAM menu Description of feature/option to be switched ON or OFF...
IBO zapper module. For a description of the original “IBO Zapper” is intended for use in combination with an TV sets (without an IBO zapper module), see the LC4.9E AA analogue TV chassis. manual, order code 3122 785 15432. The table below shows...
Page 86
EN 86 LC4.9E AB Circuit Descriptions, Abbreviation List, and IC Data Sheets PNx83xx MOJO were first sent to the Hercules input for e.g. teletext reinsertion purposes before they are passed on to the Scaler. The secundary MOJO output, which delivers CVBS signals, is...
Circuit Descriptions, Abbreviation List, and IC Data Sheets LC4.9E AB EN 87 9.10.2 Passive Standby State 9.11 Abbreviation List The set is in standby mode. The module is in off state. 0/6/12 SCART switch control signal on A/V board. 0 = loop through (AUX to TV), 6 9.10.3 Active Standby State...
Page 88
(Y/C) are reproduced LATAM LATin AMerica RGBHV Red, Green, Blue, Horizontal sync, LC04 Philips chassis name for LCD TV 2004 and Vertical sync project Read Only Memory Liquid Crystal Display Service Alignment Mode SandCastle: two-level pulse derived...
Page 89
Sound right SCART1 out SNDR-SC2-IN Sound right SCART2 out SNDR-SC2-OUT Sound right SCART2 out SOPS Self Oscillating Power Supply S/PDIF Sony Philips Digital InterFace; This is a consumer interface used to transfer digital audio SRAM Static RAM STBY STandBY SVHS...
EN 90 LC4.9E AB Circuit Descriptions, Abbreviation List, and IC Data Sheets 9.12 IC Data Sheets This section shows the internal block diagrams and pin layouts of ICs that are drawn as "black boxes" in the electrical diagrams (with the exception of "memory" and "logic" ICs).
Page 91
Circuit Descriptions, Abbreviation List, and IC Data Sheets LC4.9E AB EN 91 9.12.2 Diagram K6, TDA10046 (IC7600) Block Diagram AGC_TUN AGC_IF ANALOG DIGITAL FRONT-END ∆Σ CHANNEL ESTIMATION AND OFDM Dual AGC ∆Σ AND CORRECTION DEMODULATION OFDM Spectrum Fsamp Carrier Time...