All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by BB 0566 TV Service...
It`s Free EN 2 LC4.3E AB Technical Specifications, Connections, and Chassis Overview 1. Technical Specifications, Connections, and Chassis Overview Index of this chapter: - Mains frequency (Hz) : 50 / 60 1.1 Technical Specifications 1.2 Connection Overview Ambient conditions: 1.3 Chassis Overview...
Page 3
It`s Free Technical Specifications, Connections, and Chassis Overview LC4.3E AB EN 3 1.2.2 Rear Connections EXT1: Video RGB - In, CVBS - In/Out, Audio - In/Out AERIAL IN EXT 2 EXT 1 AUDIO C1 C2 C3 C4 E_06532_001.eps DVI-I...
Page 4
It`s Free EN 4 LC4.3E AB Technical Specifications, Connections, and Chassis Overview Chassis Overview LCD PANEL CLASS D AUDIO AMPLIFIER PANEL POWER SUPPLY SMALL SIGNAL BOARD PANEL IBO ZAPPER MODULE KEYBOARD CONTROL PANEL SIDE AV PANEL LED & IR PANEL F_15270_085.eps...
It`s Free Safety Instructions, Warnings, and Notes LC4.3E AB EN 5 2. Safety Instructions, Warnings, and Notes Index of this chapter: Notes 2.1 Safety Instructions 2.2 Warnings 2.3.1 General 2.3 Notes • Measure the voltages and waveforms with regard to the...
Page 6
For the repair of such sets nothing changes. Philips CE is producing lead-free sets (PBF) from 1.1.2005 onwards. In case of doubt whether the board is lead-free or not (or with...
It`s Free Directions for Use LC4.3E AB EN 7 3. Directions for Use You can download this information from the following websites: http://www.philips.com/support http://www.p4c.philips.com...
4.1 Cable Dressing due to the different set executions. 4.2 Service Position • Follow the disassembling instructions in described order. 4.3 Assy/Panel Removal • For other panels see LC4.3E AA Manual 4.4 Set Re-assembly (3122 785 15272). Notes: Cable Dressing F_15270_086.eps 200505...
Page 9
It`s Free Mechanical Instructions LC4.3E AB EN 9 4.3.2 IBO Zapper Module F_15270_090.eps 300505 Figure 4-6 Opening the IBO zapper module 1. Unlock the metal cover with a screwdriver (see Figure “Unlocking the metal cover of the IBO zapper module”).
It`s Free EN 10 LC4.3E AB Service Modes, Error Codes, and Fault Finding 5. Service Modes, Error Codes, and Fault Finding Index of this chapter: How to Enter 5.1 Test Points To enter SDM, use one of the following methods: 5.2 Service Modes...
Page 11
It`s Free Service Modes, Error Codes, and Fault Finding LC4.3E AB EN 11 How to Navigate Menu Explanation Use one of the following methods: 1. LLLLL. This represents the run timer. The run timer counts • When you press the MENU button on the remote control, normal operation hours, but does not count standby hours.
Page 12
It`s Free EN 12 LC4.3E AB Service Modes, Error Codes, and Fault Finding How to Exit How to Exit Switch the set to STANDBY by pressing the mains button on To exit CSM, use one of the following methods: the remote control transmitter or the television set.
Page 13
It`s Free Service Modes, Error Codes, and Fault Finding LC4.3E AB EN 13 2. Press the MENU button on the remote control transmitter. This brings up the normal user menu. 3. In the normal user menu, use the MENU UP/DOWN keys to highlight the PICTURE sub menu.
Page 14
I 2 C SERVICE UART SERVICE ComPair CONNECTOR CONNECTOR 5.4.1 Introduction ComPair (Computer Aided Repair) is a service tool for Philips Consumer Electronics products. ComPair is a further I 2 C Power 9V DC development on the European DST (service remote control), E_06532_021.eps 180804 which allows faster and more accurate diagnostics.
It`s Free Service Modes, Error Codes, and Fault Finding LC4.3E AB EN 15 Error Codes 5.5.3 Error Codes In case of non-intermittent faults, write down the errors present The error code buffer contains all errors detected since the last in the error buffer and clear the error buffer before you begin time the buffer was erased.
Page 16
It`s Free EN 16 LC4.3E AB Service Modes, Error Codes, and Fault Finding The Blinking LED Procedure Using this procedure, you can make the contents of the error buffer visible via the front LED. This is especially useful when there is no picture.
Page 17
It`s Free Service Modes, Error Codes, and Fault Finding LC4.3E AB EN 17 Table 5-3 NVM Default values (option bit settings through NVM Editor in SAM Mode) Byte Nr. Bit Feature/Mode Description Byte 0 0 QSS (LSB) Mode of quasi split sound amplifier...
Page 18
It`s Free EN 18 LC4.3E AB Service Modes, Error Codes, and Fault Finding Byte Nr. Bit Feature/Mode Description Byte 5 0 FFI Fast Filter 179(dec) 1 NNR No red reduction during blue stretch 2 MUS NTSC matrix 3 GAM...
It`s Free Block Diagrams, Testpoint Overviews, and Waveforms LC4.3E AB Block Diagram IBO Zapper IBO - ZAPPER PANEL FRONT END 7600 COMMON INTERFACE MOJO ANALOG BACK END 7502 +5VClean 7500 TDA10046HT 7700 7100 UDA1334ATS 7501 STV0700 PNX8316HS 1500 RESET_FE-N...
It`s Free Circuit Diagrams and PWB Layouts LC4.3E AB IBO Zapper: Analog Back End 1500 C13 5512 G3 2500 A7 5513 H3 2501 A6 5514 I3 ANALOG BACK END 2502 B3 5528 A5 2503 C7 6503 E5 3528 5528...
It`s Free Alignments LC4.3E AB EN 73 8. Alignments Index of this chapter: 8.1 General Alignment Conditions 8.2 Hardware Alignments 8.3 Software Alignments Note: Figures below can deviate slightly from the actual situation, due to the different set executions.
Page 74
It`s Free EN 74 LC4.3E AB Alignments 8.3.1 SAM Menu 00035 LC4XEP1 1.08/S4XGVX 1.10 ERR 0 0 0 0 0 OP 000 057 140 032 120 128 000 . OP1 . Delta Cool Red . OP2 . Delta Cool Green -1 .
Page 75
It`s Free Alignments LC4.3E AB EN 75 8.3.4 ADC Gain, Grey Scale Alignment & Panel Size Settings Caution: • Do not change the NVM settings without understanding the function of each setting, because The table below shows a number of NVM settings used for incorrect NVM settings may seriously hamper the each model of TV set.
Page 76
It`s Free EN 76 LC4.3E AB Alignments 8.3.5 Sound not via the SCALER “Options” OP1...OP7. For further settings, see also the NVM settings in the Table “ADC Gain, Grey scale alignment & panel size settings” elsewhere in this manual.
Page 77
It`s Free Alignments LC4.3E AB EN 77 Table 8-3 Option codes in detail, at bit level Option byte & bit table for restoring the SCALER to its original Factory Default settings via the SC NVM Editor in the SAM menu...
“IBO Zapper” is intended for use in combination with an set and an IBO zapper module. For a description of the original analogue TV chassis. TV sets (without an IBO zapper module), see the LC4.3E AA Block diagram IBO Zapper Module i g i l a t .
Page 79
It`s Free Circuit Descriptions, Abbreviation List, and IC Data Sheets LC4.3E AB EN 79 PNx83xx MOJO were first sent to the Hercules input for e.g. teletext reinsertion purposes before they are passed on to the Scaler. The secundary MOJO output, which delivers CVBS signals, is...
It`s Free EN 80 LC4.3E AB Circuit Descriptions, Abbreviation List, and IC Data Sheets 9.10.2 Passive Standby State 9.11 Abbreviation List The set is in standby mode. The module is in off state. 0/6/12 SCART switch control signal on A/V board.
Page 81
(Y/C) are reproduced LATAM LATin AMerica RGBHV Red, Green, Blue, Horizontal sync, LC04 Philips chassis name for LCD TV 2004 and Vertical sync project Read Only Memory Liquid Crystal Display Service Alignment Mode SandCastle: two-level pulse derived...
Page 82
Sound right SCART1 out SNDR-SC2-IN Sound right SCART2 out SNDR-SC2-OUT Sound right SCART2 out SOPS Self Oscillating Power Supply S/PDIF Sony Philips Digital InterFace; This is a consumer interface used to transfer digital audio SRAM Static RAM STBY STandBY SVHS...
It`s Free Circuit Descriptions, Abbreviation List, and IC Data Sheets LC4.3E AB EN 83 9.12 IC Data Sheets This section shows the internal block diagrams and pin layouts of ICs that are drawn as "black boxes" in the electrical diagrams (with the exception of "memory"...
Page 84
It`s Free EN 84 LC4.3E AB Circuit Descriptions, Abbreviation List, and IC Data Sheets 9.12.2 Diagram K6, TDA10046 (IC7600) Block Diagram AGC_TUN AGC_IF ANALOG DIGITAL FRONT-END ∆Σ CHANNEL ESTIMATION AND OFDM Dual AGC ∆Σ AND CORRECTION DEMODULATION OFDM Spectrum...
Need help?
Do you have a question about the LC4.3E and is the answer not in the manual?
Questions and answers